Auto eth0 what is

I want the ppp connection to start automatically on boot-up and connect to the modem which I have set up running a script in rc. This is fine. For the Ethernet interface I would like a static IP address assigned to it , and for it to start automatically also. What is the problem if I remove the line auto eth0? How can I enable both interfaces automatically?

Do you have your DNS configured? All right. If you have your ppp working that's fine. I would rather have allow-hotplug instead of auto since the former allows the detection of events after the boot. Sign up to join this community. The best answers are voted up and rise to the top. Stack Overflow for Teams — Collaborate and share knowledge with a private group. Create a free Team What is Teams? Learn more. Asked 2 years, 9 months ago. Active 2 years, 9 months ago.

Viewed 3k times. Where auto starts the interface at boot and iface calls the network interface in this case lo, loopback. If instead of configuring the interface with DHCP you want to set a static IP address and gateway replace the previous instructions with the following replace Defining gateway and broadcast is optional.

The following example shows a different configuration which runs after the network interface is enabled up or disabled down. You can run the following command to make sure bonding is working properly:. Best answer: How do I change font color in Linux? Where is eth0 in Linux? How do I bring up eth0 in Linux? How do I find the eth0 IP address in Linux? Quick Answer: How increase eth0 in Linux? Like this post? Please share to your friends:.

Even though HyperTerminal is not a part of Windows 10, the Windows 10 operating. Move the mouse pointer to the lower left corner of the screen, right-click, and. Do I need to reinstall Windows after replacing hard drive? This site uses cookies to store data.